Milan FWD L4-2.3L VIN Z (2007)
10. Remove the rear upper hog rings and backrest trim cover.
-
To install, make sure the climate controlled seat backrest manifold is correctly aligned to the foam pad, if equipped.
11. WARNING:
-
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module.Do not attempt to repair
the air bag module. Failure to do so may result in personal injury in the event of an air bag deployment.
-
Inspect the mounting surfaces of the side air bag module for any foreign objects before installing the side air bag module. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
NOTE: A backrest trim cover for a seat with a side air bag module is different than a backrest trim cover for a seat without a side air bag module.
Make sure the correct backrest trim cover is being installed.
To install, reverse the removal procedure.
12. Install the front seat backrest.
13. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
14. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
