Milan FWD L4-2.3L VIN Z (2007)
Front Seat Backrest, With Fold-Flat (Part 2)
Exploded View
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injuring the event of an accidental deployment.
-
Carry a live side air bag module with the air bag and tear seam pointed away from your body. This will reduce the risk of injury in the
event of an accidental deployment.
-
Do not set a live side air bag module down on the cover tear seam. This will reduce the risk of injury in the event of an accidental
deployment.
-
After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
Side air bag modules with damaged covers must be replaced.
-
To reduce the risk of personal injury, do not use any memory saver devices.
-
Front seat back trim covers installed on seats equipped with side air bags cannot be repaired, they are to be replaced. Cleaning is
permissible.
NOTE:
-
If a side air bag deployment took place, a new side air bag module and bolt must be installed. The side air bag module bracket on the backrest
frame should be inspected and replaced if necessary.
-
If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Only the front passenger seat can come equipped with optional fold-flat backrest.
All seats
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Fold the seat backrest down to the fold-flat position.
