Milan FWD L4-2.3L VIN Z (2007)
12. Remove the hog rings from the upper support spring and remove the foam pad.
13. Disconnect the backrest TED assembly electrical connector and detach the wiring harness retainers.
14. Remove the TED exhaust duct.
-
Cut and remove the tie strap.
-
During installation, install a new tie strap.
-
Remove the pin-type retainer and separate the exhaust duct from the TED.
15. Disconnect the backrest upper support spring from the backrest frame and remove the spring support with the TED attached.
16. If necessary, detach the backrest TED filter from the TED.
17. NOTE: Note the TED position on the support spring for installation.
Use an appropriate tool and separate the TED from the upper backrest support spring.
18. CAUTION: Cover the TED openings before removing any rivets to prevent debris from entering the TED.
Remove the 3 rivets and bracket from the TED.
19. WARNING:
-
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module.Do not attempt to repair
the air bag module. Failure to do so may result in personal injury in the event of an air bag deployment.
-
Inspect the mounting surfaces of the side air bag module for any foreign objects before installing the side air bag module. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
NOTE: A backrest trim cover for a seat with a side air bag module is different than a backrest trim cover for a seat without a side air bag module.
Make sure the correct backrest trim cover is being installed.
To install, reverse the removal procedure.
20. Install the front seat backrest.
21. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
22. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
