Milan FWD L4-2.3L VIN Z (2007)
1
Pull the side shield away from the seat cushion at the front edge and release the forward and side retainers.
2
Pull the side shield rearward to release the rear retainer and position the cushion side shield aside.
-
Return any detached retainers to the side shield.
-
To install, position the rear retainer clip on the cushion side shield through the hole in the backrest trim cover flap before attaching to the
rear edge of the seat.
5. Disconnect the seat control switch, release the cushion side shield retainers and remove the seat control switch.
6. To install, reverse the removal procedure.
7. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
8. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
