Milan FWD L4-2.3L VIN Z (2007)
Removal
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the parking brake cable from the brake caliper.
^
Pull back the parking brake lever.
^
Disconnect the cable from the parking brake lever.
^
Remove the cable conduit retaining clip.
^
Disconnect the cable from the brake caliper.
3. Remove the brake caliper flow bolt and position the brake hose aside.
^
Discard the 2 copper washers.
4. Remove the 2 brake caliper guide pin bolts and the brake caliper.
^
If a leaking or damaged caliper piston boot is found, install a new disc brake caliper.
Installation
1. Position the notch in the caliper piston so that it will correctly align with the pin on the backside of the inboard brake pad.