Milan FWD L4-2.3L VIN Z (2007)
Fluid - A/T: Service and Repair
FNR5 - Automatic Transaxle/Transmission
Transmission Fluid Drain and Refill
Transmission Fluid Drain and Refill
Material
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the transmission fluid cooler return hose from the transmission.
3. Insert the return hose into a calibrated 10L (10.5 qt) container.
4. CAUTION: To prevent damage to the transaxle, do not run the engine above idle.
NOTE: If the fluid return rate is less than 0.95L (1.0 qt) in 30 seconds, or if the return hose pulsates, check for restrictions at the pump, cooler or
cooler lines.
Run the engine at idle and pump out 3L (3.17 qt) of automatic transmission fluid.
5. Switch OFF the engine.
6. Remove the fluid level indicator from the fluid level indicator tube.
7. Add 3L (3.17 qt) of automatic transmission fluid to the transaxle.