Milan FWD L4-2.3L VIN Z (2007)
7. Tighten the 2 catalytic converter manifold bracket bolts.
^
Tighten to 20 Nm (15 ft. lbs.).
8. Install the 2 catalytic converter manifold shield bracket bolts and the bracket.
^
Tighten to 20 Nm (15 ft. lbs.).
9. Position the heat shield and install the 4 heat shield bolts.
^
Tighten to 10 Nm (89 inch lbs.).
10. Install the 2 catalytic converter manifold-to-exhaust flexible pipe nuts.
^
Install a new gasket.
^
Tighten to 40 Nm (30 ft. lbs.).
11. Position the wiring harness bracket on the stud.
12. Connect the HO2S and 2 CMS electrical connectors.
13. Install the generator air inlet duct.