Milan FWD L4-2.3L VIN Z (2007)
Impact Sensor: Service and Repair
Side Impact Sensor - B-Pillar
SIDE IMPACT SENSOR - B-PILLAR
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag SRS is involved in a collision,
inspect the sensor mounting bracket and wiring pigtail for deformation. Install and properly position the new sensor or any other
damaged SRS components whether or not the air bag is deployed.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
RH side shown, LH similar.
-
Seat and carpet removed for clarity.
