Milan FWD L4-2.3L VIN Z (2007)
5. If equipped, install the wheel speed sensor harness bolt.
-
Tighten to 23 Nm (17 ft. lbs.).
6. Position the brake caliper and anchor plate assembly and install the 2 bolts.
-
Tighten to 90 Nm (66 ft. lbs.).
7. Install the brake disc and the 2 brake disc bolts.
-
Tighten to 20 Nm (15 ft. lbs.).
8. Using the special tool, install the halfshaft into the wheel hub.
9. CAUTION: Do not tighten the halfshaft nut with the vehicle on the ground. The nut must be tightened to specification before the vehicle
is lowered onto the wheels. Wheel bearing damage will occur if the wheel bearing is loaded with the weight of the vehicle applied.
NOTE: Apply the brake to keep the halfshaft from rotating.
Install the halfshaft nut.
-
Tighten to 225 Nm (185 ft. lbs.).
