Milan FWD L4-2.3L VIN Z (2007)
8. CAUTION: To prevent damage to the transaxle, do not run the engine above idle.
NOTE: If the fluid return rate is less than 0.95L in 30 seconds, or if the return hose pulsates, check for restrictions at the pump, cooler or cooler
lines.
Run the engine at idle and pump out 3L (3.17 qt) of automatic transmission fluid.
9. Switch OFF the engine.
10. Add 3L (3.17 qt) of automatic transmission fluid to the transaxle.
11. CAUTION: To prevent damage to the transaxle, do not run the engine above idle.
Run the engine at idle and pump out 3L (3.17 qt) of automatic transmission fluid.
12. Switch OFF the engine.
13. Raise the vehicle.
14. Connect the return hose to the transmission.
15. Add 3L (3.17 qt) of automatic transmission fluid to the transaxle.
16. Install the fluid level indicator in the fluid level indicator tube.