Milan FWD L4-2.3L VIN Z (2007)
4. Install the manual control lever nut.
-
Tighten to 12 Nm (9 ft. lbs.).
5. Connect the TCM electrical connector.
6. CAUTION: Be careful not to bend the manual control lever when installing the shift cable.
Connect the shift cable end.
7. Install the air cleaner assembly.
8. Connect the battery ground cable.
9. Carry out the TCM initial learning procedure. For additional information, refer to Transmission Control Module (TCM) Initial Learning. See:
Testing and Inspection
10. Check for correct vehicle operation.
