Milan FWD L4-2.3L VIN Z (2007)
Shifter A/T: All Technical Service Bulletins
A/T - Key Stuck in Ignition/Shifter Binding
TSB 07-14-7
07/23/07
KEY STUCK IN IGNITION / SHIFTER BINDING CONDITION
FORD:
2006-2007 Fusion
LINCOLN:
2006 Zephyr
MERCURY:
2006-2007 Milan
This article supersedes TSB 07-2-1 to update the Part List.
ISSUE
Some 2006-2007 Fusion, Milan and 2006 Zephyr vehicles built before 9/4/2006 may exhibit a customer concern of the ignition key getting trapped or a
shifter slider binding condition. Most of the key trapped conditions are caused due to a binding shifter button which does not allow the pawl to contact
the park detect switch.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
If the key will not release from the ignition cylinder lock follow the Key Trapped procedure. On vehicles with a hard-to-shift shift lever into park or
slider bunching/binding then follow the Shifter Slider Binding procedure.
Key Trapped:
1.
Actuate knob button 5-10 times, observe for binding or sticky condition.
2.
Replace knob assembly if the knob sticks following Workshop Manual (WSM), Section 307-05.
NOTE
WHEN REPLACING THE SHIFT KNOB DO NOT REUSE THE SCREWS. REMOVE AND DISCARD THE SCREWS. INSTALL TWO NEW
SCREWS AND TIGHTEN TO 18 LB-IN (2 N.m). DO NOT OVER TIGHTEN THE SCREWS OR DAMAGE MAY OCCUR.
Shifter Slider Binding:
1.
If shifter slider is bunched up or binding, replace bezel assembly following WSM, Section 307-05.
NOTE
WHEN REPLACING THE BEZEL, CARE NEEDS TO BE TAKEN TO ENSURE THAT THE BRAKE SHIFT INTERLOCK OVERRIDE TAB
IS PROPERLY ALIGNED INTO ITS GUIDE. REFER TO FIGURE 1.