Milan FWD L4-2.3L VIN Z (2007)
Remove the main control valve body.
Installation
1. CAUTION: When installing the main control valve body, place the wire harness in the open space of the separate plate, being careful not
to pinch the harness. Damage to the harness will occur.
Connect the manual valve link and position the main control valve body in place.
2. Loosely install the 6 main control valve body bolts.
3. Install the suction cover gasket, cover and loosely install the 2 bolts.
4. Tighten the 8 bolts to 10 Nm (89 inch lbs.) in the sequence shown.
