Milan FWD L4-2.3L VIN Z (2007)
11. Install the transmission fluid drain plug.
-
Tighten to 47 Nm (35 ft. lbs.).
12. Remove the transmission fluid fill plug.
13. Fill the transaxle with approximately 4.7L (5 quarts) of clean automatic transmission fluid.
14. Install the fluid fill plug.
-
Tighten to 39 Nm (29 ft. lbs.).
15. With the transaxle in PARK, the vehicle on a level surface, the engine at idle (680-780 rpm) and foot pressed on the brake, move the selector
lever through each gear and allow engagement of each gear. Place the selector lever back in the PARK position.
16. Wipe the fluid level indicator cap and remove the fluid level indicator.
17. Wipe the fluid level indicator with a clean cloth.
18. NOTE: In order to get an accurate fluid level reading, the vehicle should be on a level surface. Idle the engine to reach the normal operating
