Milan FWD L4-2.3L VIN Z (2007)
All vehicles
6. NOTE: Do not damage the transaxle seals when removing the intermediate shaft.
Carefully remove the intermediate shaft while supporting both ends of the intermediate shaft.
7. Remove and discard the circlip from the outboard end of the intermediate shaft.
Installation
All vehicles
1. Install as new 30 mm (1.181 inch) circlip on the outboard end of the intermediate shaft.
2. Position the intermediate shaft in the transaxle and engage the intermediate shaft splines with the transaxle side gears. Make sure the circlip is
locked in the gear.