Milan FWD L4-2.3L VIN Z (2007)
3. CAUTION: Do not use air tools on this nut. Hold the manual control lever, while tightening the manual control lever nut, failure to the
manual control lever shaft or the TR sensor could occur.
Install the manual control lever.
-
Tighten to 22 Nm (16 ft. lbs.).
4. CAUTION: Check to make sure the manual control lever is in position "2" (same as "D" position).
Adjust the manual control lever to TR sensor D position.
1. L (LOW)
2. D (DRIVE)
3. N (NEUTRAL)
4. R (REVERSE)
5. P (PARK)
-
When in position D the marks on the manual control lever line up with the marks on the TR sensor.
5. Connect the selector lever cable and the TR sensor electrical connector.