Milan FWD L4-2.5L (2010)
Installation
1. Using the Manual Lever Seal Installer, install a new manual control lever shaft seal.
2. Install the manual control lever shaft in the transaxle case and through the TR sensor.
3. Inspect the manual pin to make sure it is correctly installed in the manual valve. If it is not, pull the manual control lever shaft out and correctly
install the manual pin in the manual valve and position the manual control lever shaft in place.
4. Using a suitable tool, install a new TR sensor roll pin.
5. Install the TR sensor detent spring and the bolt.
-
Tighten to 13 Nm (115 lb-in).
