Milan FWD V6-3.0L (2010)
Auxiliary Input / Output Jack: Service and Repair
Universal Serial Bus (USB) Cable and Port
Universal Serial Bus (USB) Cable and Port
NOTE: Fusion, Milan shown, MKZ similar.
Removal and Installation
1. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Disconnect the Universal Serial Bus (USB) cable and port-to-bezel connector.
3. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
4. NOTICE: Be careful not to flex the floor console RH side panel too much, or damage to the floor console may occur.
Remove the USB cable and port.
-
Disconnect the USB cable and port-to-Accessory Protocol Interface Module (APIM) electrical connector.
-
Carefully flex the floor console RH side panel and remove the USB cable and port.
5. To install, reverse the removal procedure.
