Milan FWD V6-3.0L (2010)
Garage Door Opener Transmitter: Programming and Relearning
Universal Transmitter Programming
NOTE: A new battery in the hand-held transmitter may allow quicker and easier training due to a more accurate transmission of the radio frequency
signal.
NOTE: The procedure below is for early build vehicles only.
1. Verify the hand-held transmitter is operative by pressing a button and observing the illumination of the indicator on the hand-held transmitter.
2. Turn the ignition to the ON position.
3. Prepare for programming the universal transmitter by erasing all 3 channels by holding down the 2 outside buttons until the red light begins to
flash (20-30 seconds). Release both buttons.
4. Select 1 of the 3 universal transmitter buttons to be used for programming.
5. Hold the end of the hand-held transmitter 25-51 mm (1-2 in) from the front surface of the universal transmitter so that the red light on the universal
transmitter can still be seen.
6. NOTE: During programming, the hand-held transmitter may automatically stop transmitting after 2 seconds, which may not be long enough to
program the universal transmitter. If programming with this type of hand-held transmitter, continue to hold the button on the universal transmitter
while pressing and releasing the hand-held transmitter button every 2 seconds.
At the same time, press the hand-held transmitter button and the desired button on the universal transmitter until the red light on the universal
transmitter flashes first slowly, and then rapidly. Release both buttons when the rapid flashing begins.
