Milan FWD V6-3.0L (2010)
7. Firmly press and hold for 5 seconds and release the just-trained universal transmitter button up to 2 separate times to activate the garage door. If,
after 2 separate times, the garage door still does not activate, press and hold the just-trained universal transmitter button and observe the red
indicator light.
-
If the red indicator light stays on constantly, the programming is complete and the device should activate when the universal transmitter button
is pressed and released.
-
If the red indicator light blinks rapidly for 2 seconds and then turns to a constant light, follow the Training a Garage Door Opener Equipped
With "Rolling Codes" - Early Build procedure to complete the programming of a rolling code-equipped device (most commonly a garage door
opener).
Training a Garage Door Opener Equipped With "Rolling Codes" - Early Build
NOTE: It may be helpful to have an assistant with this procedure.
1. At the garage door opener receiver (the motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found near where
the hanging antenna wire is attached to the motor-head unit; or it may be under the light bulb cover of the motor-head unit.
2. Turn the ignition to the ON position.
3. NOTE: Step 4 must be initiated within 30 seconds of pressing and releasing the "learn" or "smart" button.
Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer).
4. Return to the vehicle and firmly press, hold for 2 seconds and release the programmed universal transmitter button. Repeat the press/hold/release
sequence a second time and depending on the brand of the garage door opener (or other rolling code-equipped device), repeat this sequence a third
time to complete the programming process.
Training a Garage Door Opener Equipped With "Rolling Codes" - Late Build
WARNING: To avoid the risk of serious injury from the door closing, make sure that people and objects are clear of the garage door opener or
security device that is being programmed. When programming a garage door, it is advised to park outside of the garage.
NOTE: Read the instructions completely before attempting to program the Lear Car2U(R) System. Because of the steps involved, it may be helpful to
have an assistant when programming the universal transmitter. Programming the rolling code garage door opener involves time-sensitive actions. Read
the entire procedure before beginning so the procedure can be carried out in a timely fashion. If the time-sensitive actions are not carried out in a timely
fashion, the device times out and the procedure needs to be repeated.
NOTE: Make sure to keep the original remote control transmitter for use in other vehicles as well as for future Lear Car2U(R) System programming. It
is only needed for fixed code device programming.
