Milan FWD V6-3.0L (2010)
2. Remove the Front Display Interface Module (FDIM). For additional information, refer to Front Display Interface Module (FDIM) - Fusion, Milan
See: Entertainment Systems/Entertainment System Control Panel/Service and Repair/Front Display Interface Module (FDIM).
Vehicles without navigation
3. Remove the instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
All vehicles
4. NOTE: For vehicles with navigation, the 2 upper screws were removed with the FDIM.
Remove the 4 screws (2 for navigation) and the ACM.
-
Disconnect the electrical connectors.
5. To install, reverse the removal procedure.
-
Download the ACM configuration information from the scan tool. For additional information, refer to PMI in Information Bus. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
Accessory Protocol Interface Module (APIM)
Accessory Protocol Interface Module (APIM)
NOTE: Fusion, Milan shown; MKZ similar.
Removal and Installation
1. NOTE: It is necessary to record the current Accessory Protocol Interface Module (APIM) software and hardware level when a new APIM is
being installed to make sure that the new component is the same version as the component being replaced.
Retrieve and record the current APIM software and hardware level. For additional information,
Accessory Protocol Interface Module (APIM) Software Level Check See: Procedures/Accessory Protocol Interface Module (APIM) Software Level
Check.
2. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
3. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
4. NOTE: For Fusion and Milan, the APIM is removed as an assembly with the bracket.
Remove the 2 screws (Fusion, Milan) or 4 screws (MKZ) and the APIM.
-
Disconnect the APIM electrical connector.
