Milan FWD V6-3.0L (2010)
9. Disconnect the wiring harness retainers.
10. Disconnect the door latch electrical connector.
11. If equipped, disconnect the keyless entry keypad and door lock electrical connector and release from the bracket.
12. If equipped, disconnect the power mirror electrical connector.
13. Remove the 10 door module bolts and the window regulator motor electrical connector.
-
To install, tighten to 11 Nm (97 lb-in).
14. Remove the front door module. If installing a new door module, transfer parts as necessary.
15. To install, reverse the removal procedure.
-
If installing a new LH front or RH front (MKZ only) window motor, it must be initialized. For additional information, refer to Window Motor
