Milan FWD V6-3.0L (2010)
-
To install, tighten to 59 Nm (44 lb-ft).
10. Position the brake calipers aside using mechanic's wire. It is not necessary to disconnect the hydraulic brake lines.
11. Remove the bolts from the parking brake cable-to-trailing link bracket.
-
To install, tighten to 22 Nm (16 lb-ft).
12. Remove and discard the rear shock-to-trailing link lower bolts and flagnuts.
-
To install, tighten to 115 Nm (85 lb-ft) with the suspension at the bushing fastener tightening position.
13. Remove the 4 bolts and cone washers (2 each side) from the trailing links-to-vehicle body.
-
To install, tighten to 103 Nm (76 lb-ft).
NOTICE: The rear subframe must be secured to the lifting table. The rear subframe can become unstable and fall from the lifting table.
