Milan FWD V6-3.0L (2010)
NOTE: For All-Wheel Drive (AWD) vehicles, the rear differential is removed with the rear subframe.
14. Position the Powertrain Lift under the rear subframe.
15. Remove the 4 front (2 each side) bushing brace-to-body bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
16. Remove the 2 front (1 each side) mounting nuts and washers.
-
To install, tighten to 115 Nm (85 lb-ft).
17. Remove the 2 rear mounting nuts.
-
To install, tighten to 115 Nm (85 lb-ft).
18. Remove the rear subframe.
19. Transfer the components as necessary.
20. NOTE: Make sure the vehicle is at the correct vehicle ride height. For additional information, refer to Alignment.
See: Maintenance/Alignment/Specifications/General Specifications
See: Maintenance/Alignment/Service and Repair/Ride Height Measurement
To install, reverse the removal procedure.
