Milan FWD V6-3.0L (2010)
4. If equipped with an automatic transmission, remove the selector lever trim ring.
-
Using a non-marring tool, pry upward to release the retaining clips.
5. If equipped with a manual transmission, remove the gearshift knob by turning in a counterclockwise direction.
6. Open the storage compartment door and remove the floor console finish panel.
-
Using a non-marring tool, pry upward to release the retaining clips.
-
Disconnect the electrical connectors, if equipped.
7. Remove the utility tray.
-
Using a non-marring tool, pry upward to release the retaining clips.
-
Disconnect the electrical connector.
-
Disconnect the audio jack connector, if equipped.
8. Remove the 2 floor console screw covers.
9. Remove the 2 floor console front screws.
10. Disconnect the power point and bulkhead electrical connectors. Detach the electrical connector pin-type retainer.
11. NOTICE: To prevent damage to the instrument panel, place the selector lever in NEUTRAL and pull the console towards the rear of the
vehicle when removing the console.
Remove the 4 floor console screws, place the selector lever in NEUTRAL, pull the console towards the rear of the vehicle and remove the floor
console.
12. To install, reverse the removal procedure.