Milan FWD V6-3.0L (2010)
2. Close all of the doors.
3. Enter the factory set 5 digit entry code.
4. Press and hold the 3/4 button. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release
the 7/8 button a second time.
5. Release the 3/4 button. The horn chirps once if auto-unlock is disabled, or chirps once followed by a honk if auto-unlock is enabled.
Remote Memory Activation
Remote Memory Activation
1. Position the driver seat and exterior mirror(s) to the desired positions.
2. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
3. Within 3 seconds, press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
4. If a second memory setting is desired, repeat the procedure with the second RKE transmitter.
Remote Memory Deactivation
Remote Memory Deactivation
1. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
2. Within 3 seconds, press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If a second memory setting is desired to be deactivated, repeat the procedure with the second RKE transmitter.
Perimeter Lighting Feature Programming
Perimeter Lighting Feature Programming
Programming the Perimeter Lighting Feature Using the Door Lock Control Switch
NOTE: The following steps must be carried out within 30 seconds or the procedure needs to be repeated. If the procedure needs to be repeated, wait 30
seconds between programming sessions.
1. Turn the ignition switch from the OFF to the ON position.
2. Press the unlock button on the door lock control switch 3 times.
3. Turn the ignition switch from the ON to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition switch to the ON position. The horn chirps once to indicate that programming mode is entered.
6. NOTE: The unlock button must be pressed twice within 5 seconds.
Within 30 seconds of entering the programming mode, press the unlock button on the door lock control switch twice to enable/disable the
perimeter lighting feature. The horn chirps once if the perimeter lighting is disabled or a chirp followed by a honk if the perimeter lighting is
enabled.
7. Programming ends when the ignition switch state changes or times out after 2 minutes.
Stepped Unlock Programming
Stepped Unlock Programming
