Milan FWD V6-3.0L (2010)
2. Separate the manual lumbar cable from the control.
3. Route the manual lumbar cable out from the seat cushion frame.
20. Remove and discard the four recliner-to-cushion frame bolts and remove the seat backrest assembly from the seat cushion frame. See Figure 14.
NOTE:
Inboard side shown, outboard side similar.
21. Push in on the two head restraint guide sleeve release buttons and remove the head restraint
22. Remove and discard both of the head restraint guide sleeves by positioning a 3/16 in (5 mm) flatblade screwdriver at a 45° angle to the middle of
the head restraint guide sleeve Push inward and apply slight downward pressure to release the lock feature. See Figure 15.
NOTE:
The seat backrest trim cover and foam pad are removed for clarity.
NOTE:
Typical head restraint guide sleeve shown, others similar
