Milan FWD V6-3.0L (2010)
-
Tighten to 10 Nm (89 lb-in).
10. Install the side air bag bolt cover.
11. Position the backrest assembly and install the 4 recliner-to-backrest frame bolts.
-
Tighten to 55 Nm (41 lb-ft).
12. Route the side air bag wire harness down the side of the seat and through the cushion frame hole.
13. Route and attach the side air bag wire harness.
14. Connect the heated seat and side air bag electrical connectors.
-
If equipped, connect the heated seat electrical connector, route the wire harness and attach any pin-type retainers.
-
Connect the side air bag module electrical connector, then slide and engage the side air bag electrical connector locking clip. Route the wire
harness and attach any pin-type retainers.
15. Attach the first cushion trim cover J-clip to the rear of the cushion frame.
16. Attach the hook-and-loop strip and fasten the cushion trim cover around the safety belt buckle.
17. Install the LH recliner outboard cover and retainer to the recliner.
-
If equipped, route the heated seat wire harness to the LH recliner outboard cover.
