Milan FWD V6-3.0L (2010)
7. Separate 4 pin-type retainers attaching the armrest pocket cover to the backrest frame.
8. Remove the 4 armrest-to-backrest bolts and armrest assembly.
-
For installation, adjust the armrest horizontally as needed for good fit.
-
To install, tighten to 10 Nm (89 lb-in).
9. Disengage 2 clips in the armrest pocket.
10. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
backrest foam pad.
Invert the backrest cover up as far as it will go.
-
Separate the hook-and-loop strips and remove all rows of hog rings working up the backrest.
11. NOTE: The head restraint guide sleeves are keyed and will not interchange. Install the head restraint guide sleeve with the button on the LH side.
Under the backrest foam pad, squeeze the ends of the head restraint guide sleeves together and remove.
12. Remove the backrest cover.
13. To install, reverse the removal procedure.
