Milan FWD V6-3.0L (2010)
Removal
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
2. Disconnect the parking brake cable from the brake caliper.
-
Pull back the parking brake lever.
-
Disconnect the cable from the parking brake lever.
-
Remove the cable conduit retaining clip.
-
Disconnect the cable from the brake caliper.
3. Remove the brake caliper flow bolt and position the brake hose aside.
-
Discard the 2 copper washers.
