Milan FWD V6-3.0L (2010)
4. Remove the 2 brake caliper guide pin bolts and the brake caliper.
-
If a leaking or damaged caliper piston boot is found, install a new disc brake caliper.
Installation
1. Position the notch in the caliper piston so that it will correctly align with the pin on the backside of the inboard brake pad.
2. NOTE: Make sure that the brake caliper hose is not twisted.
Position the brake caliper onto the anchor plate.
3. Install the 2 brake caliper guide pin bolts.
-
To install, tighten to 26 Nm (19 lb-ft).
4. Using 2 new copper washers, position the brake hose and install the brake caliper flow bolt.
-
Tighten to 25 Nm (18 lb-ft).
5. Install the parking brake cable to the brake caliper.
-
Pull back the parking brake lever.
-
Connect the cable to the parking brake lever.
-
Install the cable conduit retaining clip.
6. Bleed the brake caliper. For additional information, refer to Brakes and Traction Control Component Bleeding.
7. Cycle the park brake several times to verify normal operation.
