Milan FWD V6-3.0L (2010)
6. Install the 2 brake pad retraction springs.
7. NOTICE: The caliper guide pin boots must be seated correctly on the anchor plate or the guide pins may become contaminated.
Inspect the guide pin boots and make sure they are seated on the anchor plate correctly. The boot has a lip that fits under the edge of the anchor
plate extension.
8. NOTE: Make sure that the brake caliper hose does not become twisted.
Position the brake caliper and install the 2 guide pin bolts.
-
Tighten to 27 Nm (20 lb-ft).
9. Fill the brake master cylinder reservoir with clean, specified brake fluid.
10. Install the wheel and tire. For additional information, refer to Wheels and Tires.
-
Apply brakes several times to verify correct brake operation.
