Milan FWD V6-3.0L (2010)
Brake Pressure Hold Valve: Service and Repair
Brake Pressure Control Valve
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3.0L and 3.5L vehicles
2. Remove the RH fender splash shield.
All vehicles
3. Remove the nut and the brake tube heat shield.
4. Disconnect the brake pressure control valve brake tube fittings, plug the tubes and the ports on the brake pressure control valve.
-
To install, tighten to 20 Nm (177 lb-in).
5. Remove the 2 brake pressure control valve bolts and the brake pressure control valve.
-
To install, tighten to 11 Nm (97 lb-in).
