Milan FWD V6-3.0L (2010)
Vacuum Pump: Service and Repair
Brake Vacuum Pump
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Detach the 3 wiring harness retainers from the subframe.
3. Disconnect the electrical connector and the selector lever cable.
-
Detach the harness retainer and position harness aside.
4. Remove the 2 transmission selector lever cable bracket nuts and position cable and bracket aside.
-
To install, tighten the nuts to 23 Nm (17 lb-ft).
5. Remove the Motor Electronics Cooling System (MECS) coolant pump bolts and position the pump aside.
-
To install, tighten the bolts to 20 Nm (177 lb-in).
6. Remove the 2 lower A/C compressor bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
7. Remove the 2 A/C compressor bracket bolts and the bracket.
-
To install, tighten the bolts to 25 Nm (18 lb-ft).
