Milan FWD V6-3.0L (2010)
8. NOTE: Lubricate the camshaft oil seal with clean engine oil.
Using the Camshaft Oil Seal Installer, Camshaft Oil Seal Protector and the Power Steering Pump Pulley Installer, install the camshaft oil seal.
9. NOTICE: Failure to use the correct special tools, assembled as shown in the illustration, will result in damage to the coolant pump pulley
and/or special tools.
Install the Camshaft Pulley Installer in the camshaft as shown in the illustration.
-
Adjust the collar on the Camshaft Pulley Installer screw to get the best thread engagement in the rear of the camshaft.
10. NOTICE: Failure to use the correct special tools, assembled as shown in the illustration, will result in damage to the coolant pump pulley
and/or special tools.
NOTE: Only the roller collared nut from the Power Steering Pump Pulley Installer (211-185) is used on Camshaft Pulley Installer (303-458).
Position the coolant pump pulley over the previously installed Camshaft Pulley Installer and on the end of the camshaft. Install the Camshaft Pulley
Installer, Power Steering Pump Pulley Installer and the Water Pump Pulley Spacer as shown in the illustration.
-
Using the Camshaft Pulley Installer, Power Steering Pump Pulley Installer and the Water Pump Pulley Spacer, install a new service coolant
pump pulley flush with the end of the camshaft.
11. Install the timing drive components. For additional information, refer to Timing Drive Components See: Timing Components/Service and
Repair/Removal and Replacement.
12. Install the coolant pump belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
Camshafts - RH
Camshafts - RH
