Milan FWD V6-3.0L (2010)
NOTE: Make sure the camshaft bearing caps are marked as instructed in the previous step.
Loosen the bolts evenly in the sequence shown.
1. Remove the camshaft bearing thrust caps (5R and 1R).
2. Remove the remaining camshaft bearing caps.
3. Remove the camshafts from the cylinder head.
Installation
1. Position the RH camshaft phaser and sprocket onto the intake camshaft.
-
Install the 3 bolts finger-tight.
2. Lubricate the RH camshafts with clean engine oil and carefully position the camshafts onto the cylinder head.
-
Align the RH camshafts as shown.
3. NOTICE: Cylinder head camshaft journal caps and cylinder heads are numbered to verify that they are assembled in their original
positions. If not reassembled in their original positions, severe engine damage may occur.
NOTICE: Do not install the camshaft journal thrust caps until all of the camshaft bearing caps have been installed or damage to the
thrust caps can occur.
NOTE: Lubricate the bearing surfaces of the RH camshaft bearing caps with clean engine oil.
Install the camshaft bearing caps.
-
Loosely install the bolts.
