Milan FWD V6-3.0L (2010)
Oil Pan: Service and Repair
Oil Pan Baffle
Oil Pan Baffle
Removal and Installation
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while
cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the oil pump screen and pickup tube. For additional information, refer to Engine Lubrication Components - Exploded View See: Engine
Lubrication Components - Exploded View and Oil Pump Screen and Pickup Tube See: Oil Pick Up/Strainer/Service and Repair/Oil Pump Screen
and Pickup Tube.
3. Remove the 8 nuts and the oil pan baffle in the following sequence.
1. To install, tighten the 4 M6 oil pan baffle nuts in 2 stages.
-
Stage 1: Tighten to 5 Nm (44 lb-in).
-
Stage 2: Tighten an additional 45 degrees.
2. Then install and tighten the 4 M8 oil pan baffle nuts in 2 stages.
-
Stage 1: Tighten to 15 Nm (133 lb-in).
-
Stage 2: Tighten an additional 45 degrees.
4. To install, reverse the removal procedure.
