Milan FWD V6-3.0L (2010)
Valve (TXV) manifold and tube assembly.
All vehicles
4. Remove the condenser-to-evaporator line fitting nut and disconnect the fitting.
-
Discard the gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the compressor manifold and tube suction fitting nut and disconnect the fitting.
-
Discard the gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the TXV manifold and tube bracket bolt.
-
To install, tighten to 8 Nm (71 lb-in).
7. Disconnect the A/C pressure transducer electrical connector and detach the wire harness from the TXV manifold and tube assembly.
8. Remove the TXV fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
9. Remove the TXV manifold and tube assembly.
10. NOTICE: Motorcraft(R) Electric A/C Compressor Oil only must be used as a refrigerant system lubricant for hybrid vehicles. Addition
of any oil other than Motorcraft(R) Electric A/C Compressor Oil to the hybrid vehicle refrigerant system will damage the electric Air
Conditioning (A/C) compressor and contaminate the refrigerant system.
To install, reverse the removal procedure.
-
Install new O-ring seals and new gasket seals.
-
Add the correct amount of clean PAG oil (non-hybrid) or electric A/C compressor oil (hybrid) to the refrigerant system.
11. Evacuate, leak test and charge the refrigerant system.
