Milan FWD V6-3.0L (2010)
REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.
-------------------------------------------------
A8 CHECK THE MIRROR POWER CIRCUIT FOR VOLTAGE (VEHICLES WITHOUT VIDEO MIRROR AND WITH SYNC)
-
Ignition OFF.
-
Disconnect: Auto-Dimming Interior Mirror C9030.
-
Ignition ON.
-
Measure the voltage between the auto-dimming interior mirror C9030-1, circuit CBP41 (BU), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to A9.
No
VERIFY the SJB fuse 41 (15A) is OK. If OK, REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation. If
not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short See: Diagrams/Electrical Diagrams/Diagrams By Number.
-------------------------------------------------
A9 CHECK THE MIRROR GROUND CIRCUIT FOR CONTINUITY (VEHICLES WITHOUT VIDEO MIRROR AND WITH SYNC)
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the auto-dimming interior mirror C9030-10, circuit GD139 (BK/YE), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to A10.
No
REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. TEST the system for normal operation.
-------------------------------------------------
A10 CHECK THE COMMUNICATION CIRCUITS FOR A SHORT TO VOLTAGE (VEHICLES WITHOUT VIDEO MIRROR AND WITH
SYNC)
-
Disconnect: IPC C220.
