Milan FWD V6-3.0L (2010)
Spark Plug: Service and Repair
Spark Plugs
Spark Plugs
Removal and Installation
1. Remove the 6 ignition coil-on-plugs. For additional information, refer to Ignition Coil-On-Plug See: Powertrain Management/Ignition
System/Ignition Coil/Service and Repair/Ignition Coil-On-Plug.
2. NOTICE: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.
NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
Remove the 6 spark plugs.
-
To install, tighten to 15 Nm (133 lb-in).
3. Inspect the 6 spark plugs. For additional information, refer to Engine.
4. To install, reverse the removal procedure.
-
Adjust the spark plug gap as necessary.