Milan FWD V6-3.0L (2010)
Yes
GO to I2.
No
VERIFY the Smart Junction Box (SJB) fuse 42 (10A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams to identify the
possible causes of the short circuit. CLEAR the DTCs. REPEAT the network test with the scan tool. See: Diagrams/Electrical Diagrams/Diagrams By
Number
-------------------------------------------------
I2 CHECK THE HCM GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable .
-
Measure the resistance between the HCM C1600-3, circuit GD121 (BK/YE), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to I3.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
I3 CHECK THE HS-CAN CIRCUITS BETWEEN THE HCM AND THE DLC FOR AN OPEN
-
Measure the resistance between the HCM C1600-14, circuit VDB04 (WH/BU), harness side and the DLC C251-6, circuit VDB04 (WH/BU),
harness side.
-
Measure the resistance between the HCM C1600-13, circuit VDB05 (WH), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
