Milan FWD V6-3.0L (2010)
-
Disconnect: SJB Fuse 39 (20A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test M. See: Pinpoint Test M: The Audio Control Module (ACM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. If the vehicle is equipped with an audio Digital Signal Processing (DSP) module, GO to AB8.
If the vehicle is not equipped with an audio DSP module, GO to AB9.
-------------------------------------------------
AB8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE AUDIO DSP MODULE DISABLED
-
Disconnect: BJB Fuses 20 (20A) and 21 (20A) (THX(R)) or Fuse 19 (25A) (Sony(R)) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
INSTALL the removed fuses. GO to Pinpoint Test W. See: Pinpoint Test W: The Audio Digital Signal Processing (DSP) Module Does Not Respond To
The Scan Tool
No
INSTALL the removed fuses. GO to AB9.
-------------------------------------------------
AB9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE HVAC MODULE DISABLED
-
Disconnect: SJB Fuse 15 (10A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test V. See: Pinpoint Test V: The HVAC Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to AB10.
If the vehicle is not equipped with an APIM, GO to AB11.
-------------------------------------------------
AB10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISCONNECTED
-
Disconnect: APIM C3342 .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
