mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3235 > < Initial Inspection and Diagnostic Overview|Page 3233
Page 103
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AC59. 

No

If the vehicle is equipped with a Global Positioning System Module (GPSM), GO to AC39. 

If the vehicle is not equipped with a GPSM, GO to AC40.

-------------------------------------------------
AC39 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE GPSM DISCONNECTED

 

-

Disconnect: GPSM C2300 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AC60. 

No

GO to AC40.

-------------------------------------------------
AC40 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE IPC DISCONNECTED

 

-

Disconnect: Instrument Panel Cluster (IPC) C220 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AC61. 

No

Initial Inspection and Diagnostic Overview|Page 3235 > < Initial Inspection and Diagnostic Overview|Page 3233