mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3260 > < Initial Inspection and Diagnostic Overview|Page 3258
Page 128
background image

CONNECT the negative battery cable. GO to AE43.

-------------------------------------------------
AE16 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE ABS MODULE DISCONNECTED

 

-

Disconnect: ABS Module C135 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a 4X4 control module, GO to AE17. 

If the vehicle is not equipped with a 4X4 control module, GO to AE18. 

No

CONNECT the negative battery cable. GO to AE44.

-------------------------------------------------
AE17 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE 4X4 CONTROL MODULE
DISCONNECTED

 

-

Disconnect: 4X4 Control Module C3253 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AE18. 

No

CONNECT the negative battery cable. GO to AE45.

-------------------------------------------------
AE18 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE RCM DISCONNECTED

 

-

Disconnect: Restraints Control Module (RCM) C310b .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

Initial Inspection and Diagnostic Overview|Page 3260 > < Initial Inspection and Diagnostic Overview|Page 3258