mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3266 > < Initial Inspection and Diagnostic Overview|Page 3264
Page 134
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE43. 

No

GO to AE30.

-------------------------------------------------
AE30 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ABS MODULE DISCONNECTED

 

-

Disconnect: ABS Module C135 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE44. 

No

If the vehicle is equipped with a 4X4 control module, GO to AE31. 

If the vehicle is not equipped with a 4X4 control module, GO to AE32.

-------------------------------------------------
AE31 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE 4X4 CONTROL MODULE
DISCONNECTED

 

-

Disconnect: 4X4 Control Module C3253 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE45. 

No

Initial Inspection and Diagnostic Overview|Page 3266 > < Initial Inspection and Diagnostic Overview|Page 3264