Milan FWD V6-3.0L (2010)
Installation
1. Install the TR sensor.
1. Install the TR sensor and park pawl actuating rod in the transaxle case.
2. Install the manual shaft in the transaxle case through the TR sensor.
2. Inspect the manual pin to make sure it is correctly installed in the manual valve. If it is not, pull the manual control lever shaft out and correctly
install the manual pin in the manual valve and position the manual control lever shaft in place.
3. Using a suitable tool, install a new TR sensor locking pin.
4. Install the TR sensor detent spring and the bolt.
-
Tighten to 13 Nm (115 lb-in).
