Milan FWD V6-3.0L (2010)
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious
personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Remove the 3 nuts and the fuel tank filler pipe heat shield.
-
To install, tighten to 10 Nm (89 lb-in).
4. Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
5. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling. For additional information, refer to Fuel Delivery and Air Induction.
6. Disconnect the fuel vapor tube assembly-to-Evaporative Emission (EVAP) canister quick connect coupling. For additional information, refer to
Fuel Delivery and Air Induction.
7. Disconnect the fuel vapor tube assembly from the fuel vapor separator and solenoid assembly.
8. Release the pin-type retainer.
9. Disconnect the fuel vapor tube assembly-to-recirculation tube quick connect coupling. For additional information, refer to Fuel Delivery and Air
Induction.
10. Remove the fuel vapor tube assembly.
11. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Testing and Inspection.
