Milan FWD V6-3.0L (2010)
25. Using a suitable depth gauge measure the distance from the top of Shim Selection Gauge # 307300 to the top of the low/reverse clutch at 3 different
points and average the 3 distances Record this as measurement E. See Figure 65.
26. Subtract measurement E from measurement D and record as measurement F.
27. Subtract measurement F from measurement C to get the low/reverse clutch clearance. The clearance should be between 0.406 mm (0.015 in) and
2.000 mm (0.078 in). If the clearance is out of range, check the low/reverse clutch pack for correct installation. If the low/reverse clutch pack is still
out of range, call the SSSC for authorization to replace the low/reverse clutch pack.
28. NOTE: When the low/reverse clutch is correctly installed, the wave spring is on top.
Remove the top low/reverse clutch steel plate and wave spring and correctly install the plates back in the transaxle case.
29. NOTE: Make sure the center support is installed with the long center support legs facing down and the feed holes facing the front of the transaxle
case. Improper alignment will cause transmission failure.
