Milan FWD V6-3.0L (2010)
3. Connect the IDS to the vehicle and start a session.
4. Select the Tool Box tab and then select Module Programming. Touch the tick.
5. Select Module Reprogramming and then select PCM. Touch the tick.
6. NOTE: If the IDS states there are no updates available, either the IDS has not been updated to software release 65.17 and higher or 66.03A and
higher, or the PCM has already been reprogrammed.
A screen will appear stating a later PCM calibration is available. Follow the on-screen instructions to program the PCM to the latest calibration.
7. After the PCM has been reprogrammed, inspect the vehicle's odometer for mileage:
^
If the mileage is LESS THAN 7,000 miles (11,265 km), remove the IDS. This service procedure is complete and no additional repairs are
necessary.
^
If the mileage is MORE THAN 7,000 miles (11,265 km), leave the IDS connected to the vehicle and proceed to Step 8.
TRANSMISSION LOAD TEST
WARNING:
Block all wheels, set the parking brake and firmly apply the service brake to reduce the risk of vehicle movement during this procedure Failure to
follow these instructions may result in serious personal injury.
8. NOTE: In order to perform a valid Transmission Load Test, Transmission Fluid Temperature (TFT) must be between 185-200° F (85-93° C).
Using the IDS, make sure the Transmission Fluid Temperature (TFT) is at an operating temperature of 185-200° F (85-93° C). If the TFT is BELOW
185-200° F (85-93° C), perform the following:
^
With the vehicle's brakes applied, start the engine.
^
Place the gear selector in D, bring the engine up to 1500 rpm and hold for one minute.
^
Place the gear selector in N and allow the engine to idle for one minute.
^
Place the gear selector in R and bring the engine up to 1500 rpm for one minute.
^
Place the gear selector in N and allow the engine to idle for one minute.
^
Repeat this procedure until the vehicle's TFT is 185-200° F (85-93° C).
9. Perform the Transmission Load Test:
NOTE:
Conduct this test after the PCM has been reprogrammed. Make sure that the engine coolant and transmission fluid is at normal operating
temperature and fluid levels are correct.
1. Block all wheels, set the parking brake, and firmly apply the service brakes.
2. Turn off Traction Control if equipped
3. Set the IDS to record engine rpm and TSS_SRC rpm.
4. Place the gear selector in D.
