Milan FWD V6-3.0L (2010)
2. Remove the bolt and the KS.
Engine block-mounted
3. Remove the lower intake manifold. For additional information, refer to Engine.
4. Disconnect the KS electrical connector.
5. Remove the bolt and the KS.
Installation
Engine block-mounted
1. Install the KS and the bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
2. Connect the KS electrical connector.
3. Install the lower intake manifold. For additional information, refer to Engine.
Cylinder head-mounted
4. Install the KS and the bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Connect the KS electrical connector.
